C315 Indoor Monitor Administraor Guide
11 Intercom Call Configuration
11.1
IP call & IP Call Configuration
IP calls and SIP calls can be made directly on the intercom device by entering the IP
number on the device. And you can also disable the direct IP call if you allow no IP call to
be made on the device. To configure the IP call feature and port on the device web Phone
> Call Feature > Others interface.
Parameter Set-up:
•
Direct IP Call: enable the direct IP call. For example, if you do not allow direct IP calls
to be made on the device, you can untick the check box to terminate the function.
•
Direct IP Call Port: the direct IP Call Port is 5060 by default with the port range
from 1-65535. If you enter any values within the range other than 5060, you are
required to check if the value entered is consistent with the corresponding value on
the device you wish to establish a data transmissionwith.
To Next Page
Loading...
