Akuvox C315 Series - Remote Relay Switch Setting; Web Relay Setting

C315 Indoor Monitor Administraor Guide
www.akuvox.com
88
• Open door: when you press the unlock icon, the local relay will be opened.
• Other Switchs (Reset By Event): select it when you want the relay to be
triggered automatically by the incoming call or the alarm that goes off.
• Relay Display Name: give a name to the relay for identification.
• Remote Control: enable it to trigger local relays by DTMF and viceversa.
16.1.2 Remote Relay Switch Setting
You can use the unlock tab during the call to open the door on web Phone > Relay > Relay
Setting > Remote Relay interface. You are required to set up the same DTMF code in the
door phone and indoor monitor.
Parameter Set-up:
• DTMF Code: to set DTMF code for the remote relay, which is # bydefault.
16.2 Web Relay Setting
In addition to the relay that is connected to indoor monitor, you can also control the door
access using the network-based web relay. To do this configuration on web Phone > Relay
> Web Relay interface.