C315 Indoor Monitor Administraor Guide
•
Status: set the alarm sensor status among three options: Enable, Disable, and 24H.
Select Enable if you want to enable the alarm, however, you are required to set the
alarm again after an alarm is disarmed. Select Disable if you want to disable the
alarm, and select 24H if you want the alarm sensor to stay enabled for 24 hours
without needing to set up the alarm manually again after the alarm is disarmed.
15.3.3
Configure Location-based Alarm
Configure the alarm sensor in the same way you do on the web interface.
Parameters Set-up:
•
Location: to select which location the detection device is located, including Bedroom,
Guest room, Hall, Window, Balcony, Kitchen, Study, and Bathroom.
•
Zone type: to select the type of detection device, including Infrared, Drmagnet,
Smoke, Gas, and Urgency.
•
Defence delay: it means when users enable the arming mode, there will be90
seconds delay time for the alarm mode to be activated.
To Next Page
Loading...
Need help?
General
