Alcatel-Lucent 7210 SAS M - Page 178

Show Commands
Page 178 7210 SAS M, T, X, R6, Mxp MPLS Configura-
tion Guide
Interface Port-id Adm Opr TE-metric
-------------------------------------------------------------------------------
system system Up Up None
Admin Groups None
Srlg Groups None
ip-10.10.2.3 1/1/15 Up Up None
Admin Groups None
Srlg Groups None
ip-10.10.5.3 1/1/1 Up Up None
Admin Groups None
Srlg Groups None
ip-10.10.11.3 1/1/3 Up Up None
Admin Groups None
Srlg Groups None
ip-10.10.12.3 lag-1 Up Up None
Admin Groups None
Srlg Groups None
-------------------------------------------------------------------------------
Interfaces : 5
===============================================================================
*A:7210SAS#
label
Syntax label start-label [end-label | in-use | label-owner]
Context show>router>mpls
Description Displays MPLS labels exchanged.
Parameters start-label — The label value assigned at the ingress router.
end-label — The label value assigned for the egress router.
in-use — The number of in-use labels displayed.
Output MPLS Label Output Fields — The following table describes MPLS label output fields.
Sample Output
*A:SRU4>config>router>mpls# show router mpls label 202
=================================================================
MPLS Label 202
=================================================================
Label Label Type Label Owner
-----------------------------------------------------------------
Label Description
Label
Displays the value of the label being displayed.
Label Type
Specifies whether the label value is statically or dynamically assigned.
Label Owner
The label owner.
In-use labels in
entire range
The total number of labels being used by RSVP.