Login, Telnet, SSH and FTP Commands
Page 128 7450 ESS System Mangement Guide
2 — Specifies that the SSH server will accept connections from clients supporting
either SSH protocol version 2
server-shutdown
Syntax [no] server-shutdown
Context config>system>security>ssh
Description This command enables the SSH servers running on the system.
Default At system startup, only the SSH server is enabled.
version
Syntax version ssh-version
no version
Context config>system>security>ssh
Description Specifies the SSH protocol version that will be supported by the SSH server.
Default 2
Parameters ssh-version — Specifies the SSH version.
Values 1 — Specifies that the SSH server will only accept connections from clients that
support SSH protocol version 1
2 — Specifies that the SSH server will accept connections from clients supporting
either SSH protocol version 2
1-2 — Specifies that the SSH server will accept connections from clients support-
ing either SSH protocol version 1, or SSH protocol version 2 or both.
telnet
Syntax telnet
Context config>system>login-control
Description This command creates the context to configure the Telnet login control parameters.
enable-graceful-shutdown
Syntax [no] enable-graceful-shutdown
To Next Page
Loading...
