Alcatel-Lucent 7450 - Modifying an SNMP Trap Group

Event and Accounting Logs
7450 ESS System Mangement Guide Page 447
Example: config# log
config>log# no syslog 1
Modifying an SNMP Trap Group
Use the following CLI syntax to modify an SNMP trap group:
CLI Syntax: config>log
snmp-trap-group log-id
trap-target name [address ip-address] [port port] [sn-
mpv1|snmpv2c| snmpv3] notify-community communi-
tyName |snmpv3SecurityName [security-level {no-
auth-no-privacy|auth-no-privacy|privacy}]
The following displays the current SNMP trap group configuration:
A:ALA-12>config>log# info
----------------------------------------------
...
snmp-trap-group 10
trap-target 10.10.10.104:5 "snmpv3" notify-community "coummunitystring"
exit
...
----------------------------------------------
A:ALA-12>config>log#
The following displays an example of the command usage to modify an SNMP trap group:
Example: config# log
config>log# snmp-trap-group 10
config>log>snmp-trap-group# no trap-target 10.10.10.104:5
config>log>snmp-trap-group# snmp-trap-group# trap-target
10.10.0.91:1 snmpv2c notify-community "com1"
The following displays the SNMP trap group configuration:
A:ALA-12>config>log# info
----------------------------------------------
...
snmp-trap-group 10
trap-target
10.10.0.91:1 "snmpv2c" notify-community "com1”
exit
...
----------------------------------------------
A:ALA-12>config>log#