Alcatel-Lucent 7450 - Configuring Access Options

Configuring Access Options
Page 296 7450 ESS System Mangement Guide
community "uTdc9j48PBRkxn5DcSjchk" hash2 rwa version both
community "Lla.RtAyRW2" hash2 r version v2c
community "r0a159kIOfg" hash2 r version both
----------------------------------------------
*A:cses-A13>config>system>security>snmp#
Configuring Access Options
The access command creates an association between a user group, a security model and the views
that the user group can access. Access must be configured unless security is limited to the
preconfigured access groups and views for SNMPv1 and SNMPv2. An access group is defined by
a unique combination of the group name, security model and security level.
Use the following CLI syntax to configure access features:
CLI Syntax: config>system>security>snmp
access group group-name security-model security-model secu-
rity-level security-level [context context-name [pre-
fix-match]] [read view-name-1] [write view-name-2]
[notify view-name-3]
The following displays an access configuration with the view configurations.
*A:cses-A13>config>system>security>snmp# info
----------------------------------------------
view "testview" subtree "1"
mask ff
exit
view "testview" subtree "1.3.6.1.2"
mask ff type excluded
exit
access group "test" security-model usm security-level auth-no-pr
ivacy read "testview" write "testview" notify "testview"
community "uTdc9j48PBRkxn5DcSjchk" hash2 rwa version both
community "Lla.RtAyRW2" hash2 r version v2c
community "r0a159kIOfg" hash2 r version both
----------------------------------------------
*A:cses-A13>config>system>security>snmp#
Use the following CLI syntax to configure user group and authentication parameters:
CLI Syntax: config>system>security# user user-name
access [ftp] [snmp] [console]
snmp
authentication [none]|[[hash]{md5 key|sha key } privacy
{none|des-key|aes-128-cfb-key key}]
group group-name