Alcatel-Lucent 7450 - Configuring RADIUS Authorization

Configuring RADIUS Authorization
Page 88 7450 ESS System Mangement Guide
Configuring RADIUS Authorization
In order for RADIUS authorization to function, RADIUS authentication must be enabled first. See
Configuring RADIUS Authentication on page 87.
In addition to the local configuration requirements, VSAs must be configured on the RADIUS
server. See Vendor-Specific Attributes (VSAs) on page 51.
On the local router, use the following CLI commands to configure RADIUS authorization:
CLI Syntax: config>system>security
radius
authorization
The following displays a RADIUS authorization configuration example:
A:ALA-1>config>system>security# info
----------------------------------------------
...
radius
authorization
retry 5
timeout 5
server 1 address 10.10.10.103 secret "test1"
server 2 address 10.10.0.1 secret "test2"
server 3 address 10.10.0.2 secret "test3"
server 4 address 10.10.0.3 secret "test4"
exit
...
----------------------------------------------
A:ALA-1>config>system>security#