Alcatel-Lucent 7450 - Table 53: Show Log Syslog Output Fields

Show Commands
Page 542 7450 ESS System Mangement Guide
Version : v2c
Community : ntttesting
Sec. Level : none
Replay : disabled
Replay from : n/a
Last replay : never
-------------------------------------------------------------------------------
Name : test2
Address : 20.20.20.5
Port : 162
Version : v2c
Community : ntttesting
Sec. Level : none
Replay : disabled
Replay from : n/a
Last replay : never
===============================================================================
A:SetupCLI>config>log>snmp-trap-group#
syslog
Syntax syslog [syslog-id]
Context show>log
Description This command displays syslog event log destination summary information or detailed information on
a specific syslog destination.
Parameters syslog-id — Displays detailed information on the specified syslog event log destination.
Values 1 — 10
Output Syslog Event Log Destination Summary Output — The following table describes the syslog
output fields.
Table 53: Show Log Syslog Output Fields
Label Description
Syslog ID
The syslog ID number for the syslog destination.
IP Address
The IP address of the syslog target host.
Port
The configured UDP port number used when sending syslog messages.
Facility
The facility code for messages sent to the syslog target host.
Severity Level
The syslog message severity level threshold.
Below Level
Dropped
A count of messages not sent to the syslog collector target because the
severity level of the message was above the configured severity. The
higher the level, the lower the severity.