Configuring an Event Log
Page 422 7450 ESS System Mangement Guide
Common Configuration Tasks
The following sections are basic system tasks that must be performed.
• Configuring a File ID on page 424
• Configuring an Event Log on page 422
• Configuring an Accounting Policy on page 425
• Configuring Event Control on page 426
• Configuring a Log Filter on page 428
• Configuring an SNMP Trap Group on page 429
• Configuring a Syslog Target on page 437
Configuring an Event Log
A event log file contains information used to direct events, alarms, traps, and debug information to
their respective destinations. One or more event sources can be specified. File IDs, SNMP trap
groups, or syslog IDs must be configured before they can be applied to an event log ID.
Use the following CLI syntax to configure a log file:
CLI Syntax: config>log
log-id log-id
description description-string
filter filter-id
from {[main] [security] [change] [debug-trace]}
to console
to file file-id
to memory [size]
to session
to snmp [size]
to syslog syslog-id}
time-format {local|utc}
no shutdown
To Next Page
Loading...
