Alcatel-Lucent 7450 - Setting the Replay Parameter

Event and Accounting Logs
7450 ESS System Mangement Guide Page 431
Setting the Replay Parameter
For this example the replay parameter was set by a SNMP SET request for the trap-target address
10.10.10.3 which is bound to port-id 1/1/1.
A:SetupCLI>config>log>snmp-trap-group 44
A:SetupCLI>config>log>snmp-trap-group# info
----------------------------------------------
trap-target "xyz-test" address 10.10.10.3 snmpv2c notify-community "xyztesting"
replay
trap-target "test2" address 20.20.20.5 snmpv2c notify-community "xyztesting"
----------------------------------------------
A:SetupCLI>config>log>snmp-trap-group#
In the following output, note that the Replay field changed from disabled to enabled.
A:SetupCLI>config>log>snmp-trap-group# show log snmp-trap-group 44
===============================================================================
SNMP Trap Group 44
===============================================================================
Description : none
-------------------------------------------------------------------------------
Name : xyz-test
Address : 10.10.10.3
Port : 162
Version : v2c
Community : xyztesting
Sec. Level : none
Replay : enabled
Replay from : n/a
Last replay : never
-------------------------------------------------------------------------------
Name : test2
Address : 20.20.20.5
Port : 162
Version : v2c
Community : xyztesting
Sec. Level : none
Replay : disabled
Replay from : n/a
Last replay : never
===============================================================================
A:SetupCLI>config>log>snmp-trap-group#