Event and Accounting Logs
7450 ESS System Mangement Guide Page 541
snmp-trap-group
Syntax snmp-trap-group [log-id]
Context show>log
Description This command displays SNMP trap group configuration information.
Parameters log-id — Displays only SNMP trap group information for the specified trap group log ID.
Values 1 — 99
Output SNMP Trap Group Output — The following table describes SNMP trap group output fields.
Sample Output
A:SetupCLI>config>log>snmp-trap-group# show log snmp-trap-group 44
===============================================================================
SNMP Trap Group 44
===============================================================================
Description : none
-------------------------------------------------------------------------------
Name : ntt-test
Address : 10.10.10.3
Port : 162
Table 52: SNMP Trap Group Output Fields
Label Description
Log-ID
The log destination ID for an event stream.
Address
The IP address of the trap receiver,
Port
The destination UDP port used for sending traps to the destination,
expressed as a decimal integer.
Version
Specifies the SNMP version format to use for traps sent to the trap
receiver. Valid values are snmpv1, snmpv2c, snmpv3.
Community
The community string required by snmpv1 or snmpv2c trap receivers.
Security-Level
The required authentication and privacy levels required to access the
views on this node.
Replay
Indicates whether or not the replay parameter has been configured,
enabled or disabled, for the trap-target address.
Replay from
Indicates the sequence ID of the first missed notification that will be
replayed when a route is added to the routing table by which trap-target
address can be reached. If no notifications are waiting to be replayed
this field shows n/a.
Last Replay
Indicates the last time missed events were replayed to the trap-target
address. If no events have ever been replayed this field shows never.
To Next Page
Loading...
