Configuring Event Control
Page 426 7450 ESS System Mangement Guide
Configuring Event Control
Use the following CLI syntax to configure event control. Note that the throttle parameter used in
the event-control command syntax enables throttling for a specific event type. The
config>log>throttle-rate command configures the number of events and interval length to be
applied to all event types that have throttling enabled by this event-control command.
CLI Syntax: config>log
event-control application-id [event-name|event-number] gen-
erate [severity-level] [throttle]
event-control application-id [event-name|event-number] sup-
press
throttle-rate events [interval seconds]
The following displays an event control configuration:
A:ALA-12>config>log# info
#------------------------------------------
echo "Log Configuration"
#------------------------------------------
throttle-rate 500 interval 10
event-control "oam" 2001 generate throttle
event-control "ospf" 2001 suppress
event-control "ospf" 2003 generate cleared
event-control "ospf" 2014 generate critical
..
----------------------------------------------
A:ALA-12>config>log>filter#
To Next Page
Loading...
