SNMP
7450 ESS System Mangement Guide Page 297
The following displays a user’s SNMP configuration example.
A:ALA-1>config>system>security# info
----------------------------------------------
user "testuser"
access snmp
snmp
authentication hash md5 e14672e71d3e96e7a1e19472527ee969 privacy none
group testgroup
exit
exit
...
----------------------------------------------
A:ALA-1>config>system>security#
Configuring USM Community Options
User-based security model (USM) community strings associate a community string with an
SNMPv3 access group and its view. The access granted with a community string is restricted to
the scope of the configured group.
By default, the OS implementation of SNMP uses SNMPv3. However, to implement SNMPv1
and SNMPv2c, USM community strings must be explicitly configured.
Use the following CLI syntax to configure USM community options:
CLI Syntax: config>system>security>snmp
usm-community community-string group group-name
The following displays a SNMP community configuration example:
A:ALA-1>config>system>security>snmp# info
----------------------------------------------
view "testview" subtree "1"
mask ff
exit
view "testview" subtree "1.3.6.1.2"
mask ff type excluded
exit
access group "test" security-model usm security-level auth-no-pr
ivacy read "testview" write "testview" notify "testview"
community "uTdc9j48PBRkxn5DcSjchk" hash2 rwa version both
community "Lla.RtAyRW2" hash2 r version v2c
community "r0a159kIOfg" hash2 r version both
----------------------------------------------
A:ALA-1>config>system>security>snmp#
The group grouptest was configured in the config>system>security>snmp>access CLI context.
To Next Page
Loading...
