Security Commands
Page 250 7450 ESS System Mangement Guide
Parameters detail — Include the adapted operational rate parameters in the CLI output. The adapted Oper.
parameters are only applicable if the policer is instantiated (for example, if the associated
forwarding plane is operational, or for an interface if there is a physical port configured for the
interface, or if the dynamic policers are allocated), otherwise values of 0 kbps, etc are displayed.
Output Distributed CPU Protection Policer Output — The following table describes Distributed CPU
Protection Policer Output output fields.
pol
Table 18: Show Distributed CPU Protection Policer Output Fields
Label Description
Distributed CPU Pro-
tection Policy
The DCP policy assigned to the object.
Policer-Name
The configured name of the static policer
Card/FP
The card and FP identifier. FP identifies the instance of the FP
(FastPath) chipset. Some cards have a single FP (for example,
IOM3-XP) and some cards can contain multiple FPs (for example,
an IOM2 has two FPs and an XCM can house two FPs via its two
XMAs).
Policer-State
The state of the policer with the following potential values:
Exceed - The policer has been detected as non-conformant to the
associated DCP policy parameters (e.g. packets exceeded the config-
ured rate and the DCP polling process identified this occurence)
Conform - The policer has been detected as conformant to the associ-
ated DCP policy parameters (rate)
not-applicable - Newly created policers or policers that are not cur-
rently instantiated. This includes policers configured on linecards
that are not in service.
Protocols Mapped
A list of protocols that are configured to map to the particular
policer.
Oper. xyz fields
The actual hardware may not be able to perfectly rate limit to the
exact configured rate parameters in a DCP policy. In this case the
configured rate parameters will be adapted to the closest supported
rate. These adapted operational values are displayed in CLI when
the “detail” keyword is included in the show command. The
adapted Oper. parameters are only applicable if the policer is instan-
tiated (e.g. if the associated forwarding plane is operational, or for an
interface if there is a physical port configured for the interface, or if
the dynamic policers are allocated), otherwise values of 0 kbps, etc
are displayed.
To Next Page
Loading...
