Security
7450 ESS System Mangement Guide Page 251
Sample Output
*A:Dut-A# show router interface "test" dist-cpu-protection detail
===============================================================================
Interface "test" (Router: Base)
===============================================================================
Distributed CPU Protection Policy : dcpuPol
-------------------------------------------------------------------------------
Statistics/Policer-State Information
Oper. Kbps - The adapted ‘kilobits-per-second’ value for DCP ‘kbps’
rates
Oper. MBS - The adapted ‘mbs size’ value for DCP ‘kbps’ rates
Oper. Depth - The calculated policer bucket depth in packets (for
DCP ‘packets’ rates) or in bytes (for DCP ‘kbps’rates)
Oper. Packets - The adapted ‘ppi’ value for DCP ‘packets’ rates
Oper. Within - The adapted ‘within seconds’ value for DCP ‘packets’
rates
Oper. Init. Delay - The adapted ‘initial-delay packets’ value for DCP
‘packets’ rates
Exceed-Count
The count of packets exceeding the policing parameters since the
given policer was previously declared as conformant or newly
instantiated. This counter has the same behavior as the exceed
counter in the DCP the log events – they are baselined (reset) when
the policer transitions to conformant.
Detec. Time Remain
The remaining time in the detection-time countdown during which a
policer in the exceed state is being monitored to see if it is once again
conformant.
Hold-Down Remain
The remaining time in the hold-down countdown during which a
policer is treating all packets as exceeding.
All Dyn-Plcr Alloc.
Indicates that all the dynamic enforcement policers have been allo-
cated and instantiated for a given local-monitor.
Dyn-Policer Alloc.
Indicates that a dynamic policer has been instantiated.
Table 18: Show Distributed CPU Protection Policer Output Fields (Continued)
Label Description
To Next Page
Loading...
