Alcatel-Lucent 7450 - Table 16: Show Distributed CPU Protection Output Fields

Security
7450 ESS System Mangement Guide Page 245
eth-cfm-monitoring
Syntax eth-cfm-monitoring [{service-id service-id sap-id sap-id} | {service-id service-id sdp-id
sdp-id:vc-id}]
Context show>system>security>cpu-protection
Description This command displays sources exceeding their eth-cfm-monitoring rate limit.
dist-cpu-protection
Syntax dist-cpu-protection
Context show>card>fp
Description This command displays Distributed CPU Protection parameters and status at the per card and
forwarding plane level.
Output
*A:nodeA# show card 1 fp 1 dist-cpu-protection
Table 16: Show Distributed CPU Protection Output Fields
Label Description
Card
The card identifier
Forwarding
Plane(FP)
Identifies the instance of the FP (FastPath) chipset. Some cards have
a single FP (for example, an IOM3-XP) and some cards can contain
multiple FPs (for example, an IOM2 has two FPs and an XCM can
house two FPs via its two XMAs).
Dynamic Enforcement
Policer Pool
The configured size of the dynamic-enforcement-policer-pool for
this card/FP.
Dynamic-Policers
Currently In Use
The number of policers from the dynamic enforcement policer pool
that are currently in use. The policers are allocated from the pool and
instantiated as per-object-per-protocol dynamic enforcement policers
after a local monitor triggered for an object (such as a SAP or Net-
work Interface).
Hi-WaterMark Hit
Count
The maximum Currently In Use value since it was last cleared (clear
card x fp y dist-cpu-protection)
Hi-WaterMark Hit
Time
The time at which the current Hi-WaterMark Hit Count was first
recorded.
Dynamic-Policers
Allocation Fail
Count
Indicates how many times the system attempted to allocate dynamic
enforcement policers but could not get enough the fill the request.