Alcatel-Lucent 7450 - Enabling SSH

Security
7450 ESS System Mangement Guide Page 95
Enabling SSH
Use the SSH command to configure the SSH server as SSH1, SSH2 or both. The default is SSH2
(
SSH version 2). This command should only be enabled or disabled when the SSH server is
disabled. This setting should not be changed while the SSH server is running since the actual
change only takes place after SSH is disabled or enabled.
CLI Syntax: config>system>security
ssh
preserve-key
no server-shutdown
version ssh-version
The following displays a SSH server configuration as both SSH and SSH2 using a host-key:
A:sim1>config>system>security>ssh# info
----------------------------------------------
preserve-key
version 1-2
----------------------------------------------
A:sim1>config>system>security>ssh#