Configuring SNMPv3
Page 294 7450 ESS System Mangement Guide
Configuring SNMP Components
Use the CLI syntax displayed below to configure the following SNMP scenarios:
• Configuring a Community String on page 295
• Configuring View Options on page 295
• Configuring Access Options on page 296
• Configuring USM Community Options on page 297
• Configuring Other SNMP Parameters on page 298
CLI Syntax: config>system>security>snmp
attempts [count] [time minutes1] [lockout minutes2]
community community-string access-permissions [version SNMP
version]
usm-community community-string group group-name
view view-name subtree oid-value
mask mask-value [type {included|excluded}]
access group group-name security-model security-model secu-
rity-level security-level [context context-name [pre-
fix-match]] [read view-name-1] [write view-name-2]
[notify view-name-3]
To Next Page
Loading...
