Management Access Filter Commands
Page 130 7450 ESS System Mangement Guide
Management Access Filter Commands
management-access-filter
Syntax [no] management-access-filter
Context config>system>security
Description This command creates the context to edit management access filters and to reset match criteria.
Management access filters control all traffic in and out of the
CPM. They can be used to restrict man-
agement of the router by other nodes outside either specific (sub)networks or through designated
ports.
Management filters, as opposed to other traffic filters, are enforced by system software.
The no form of the command removes management access filters from the configuration.
Default No management access filters are defined.
ip-filter
Syntax [no] ip-filter
Context config>system>security>mgmt-access-filter
Description This command enables the context to configure management access IP filter parameters.
mac-filter
Syntax [no] mac-filter
Context config>system>security>mgmt-access-filter
Description This command configures a management access MAC-filter.
action
Syntax action {permit | deny | deny-host-unreachable}
no action
Context config>system>security>mgmt-access-filter>ip-filter>entry
Description This command creates the action associated with the management access filter match criteria entry.
The action keyword is required. If no action is defined, the filter is ignored. If multiple action state-
ments are configured, the last one overwrites previous configured actions.
To Next Page
Loading...
