Security
7450 ESS System Mangement Guide Page 135
new-entry-number — Enter the new entry number that will replace the old entry number.
Values 1 — 9999
shutdown
Syntax [no] shutdown
Context config>system>security>mgmt-access-filter>ip-filter
config>system>security>mgmt-access-filter>mac-filter
Description This command shutdowns the management-access-filter.
match
Syntax match [frame-type frame-type]
no match
Context config>system>security>mgmt-access-filter>mac-filter>entry
Description This command configures math criteria for this MAC filter entry.
Parameters frame-type frame-type — Specifies the type of MAC frame to use as match criteria.
Values none, 802dot2-llc, ethernet_II
cfm-opcode
Syntax cfm-opcode {lt | gt | eq} opcode
cfm-opcode range start end
no cfm-opcode
Context config>system>security>mgmt-access-filter>mac-filter>entry
Description This command specifies the type of opcode checking to be performed.
If the cfm-opcode match condition is configured then a check must be made to see if the Ethertype is
either IEEE802.1ag or Y1731. If the Ethertype does not match then the packet is not CFM and no
match to the cfm-opcode is attempted.
The CFM (ieee802.1ag or Y1731) opcode can be assigned as a range with a start and an end number
or with a (less than lt, greater than gt, or equal to eq) operator.
If no range with a start and an end or operator (lt, gt, eq) followed by an opcode with the value
between 0 and 255 is defined then the command is invalid.
To Next Page
Loading...
