TACACS+ Client Commands
Page 184 7450 ESS System Mangement Guide
shutdown
Syntax [no] shutdown
Context config>system>security>tacplus
Description This command administratively disables the TACACS+ protocol operation. Shutting down the proto-
col does not remove or change the configuration other than the administrative state.
The operational state of the entity is disabled as well as the operational state of any entities contained
within. Many objects must be shut down before they may be deleted.
The no form of the command administratively enables the protocol which is the default state.
Default no shutdown
tacplus
Syntax [no] tacplus
Context config>system>security
Description This command creates the context to configure TACACS+ authentication on the router.
Configure multiple server addresses for each router for redundancy.
The no form of the command removes the TACACS+ configuration.
accounting
Syntax accounting [record-type {start-stop | stop-only}]
no accounting
Context config>system>security>tacplus
Description This command configures the type of accounting record packet that is to be sent to the TACACS+
server. The record-type parameter indicates whether TACACS+ accounting start and stop packets be
sent or just stop packets be sent.
Default record-type stop-only
Parameters record-type start-stop — Specifies that a TACACS+ start packet is sent whenever the user executes
a command.
record-type stop-only — Specifies that a stop packet is sent whenever the command execution is
complete.
authorization
Syntax [no] authorization [use-priv-lvl]
To Next Page
Loading...
