Keychain Authentication
Page 190 7450 ESS System Mangement Guide
Keychain Authentication
keychain
Syntax [no] keychain keychain-name
Context config>system>security
Description This command enables the context to configure keychain parameters. A keychain must be configured
on the system before it can be applied to a session.
The no form of the command removes the keychain nodal context and everything under it from the
configuration. If the keychain to be removed is in use when the no keychain command is entered, the
command will not be accepted and an error indicating that the keychain is in use will be printed.
Default none
Parameters keychain-name — Specifies a keychain name which identifies this particular keychain entry.
Values An ASCII string up to 32 characters.
direction
Syntax direction
Context config>system>security>keychain
Description This command specifies the data type that indicates the TCP stream direction to apply the keychain.
Default none
bi
Syntax bi
Context config>system>security>keychain>direction
Description This command configures keys for both send and receive stream directions.
Default none
uni
Syntax uni
Context config>system>security>keychain>direction
To Next Page
Loading...
