Security
7450 ESS System Mangement Guide Page 201
Description
dscp
Syntax dscp dscp-name
no dscp
Context config>sys>sec>cpm>ip-filter>entry>match
config>sys>sec>cpm>mac-filter>entry>match
Description This command configures a DiffServ Code Point (DSCP) name to be used as an IP filter match crite-
rion.
The no form of the command removes the DSCP match criterion.
Default no dscp — No dscp match criterion.
Parameters dscp-name — Configures a dscp name that has been previously mapped to a value using the dscp-
name command. The DiffServ code point may only be specified by its name.
dst-ip
Syntax dst-ip ipv6-address/prefix-length
dst-ip ipv6-prefix-list ipv6-prefix-list-name
no dst-ip
Context config>sys>sec>cpm>ip-filter>entry>match
Description This command configures a destination IP address range to be used as an IP filter match criterion.
To match on the destination IP address, specify the address and its associated mask, for example,
10.1.0.0/16. The conventional notation of 10.1.0.0 255.255.0.0 may also be used.
pnni 102 PNNI over IP
pim 103 Protocol Independent Multicast
vrrp 112 Virtual Router Redundancy Protocol
l2tp 115 Layer Two Tunneling Protocol
stp 118 Spanning Tree Protocol
ptp 123 Performance Transparency Protocol
isis 124 ISIS over IPv4
crtp 126 Combat Radio Transport Protocol
crudp 127 Combat Radio User Datagram
Table 10: IP Protocol Names (Continued)
Protocol Protocol ID Description
To Next Page
Loading...
