Security
7450 ESS System Mangement Guide Page 219
cpu-protection
Syntax cpu-protection policy-id
no cpu-protection
Context config>router>interface
config>service>ies>interface
config>service>ies>video-interface
config>service>vpls>video-interface
config>service>vprn>interface
config>service>vprn>network-interface
config>service>vprn>video-interface
Description Use this command to apply a specific CPU protection policy to the associated interface. For these
interface types, the per-source rate limit is not applicable.
If no CPU-protection policy is assigned to an interface, then the default policy is used to limit the
overall-rate. The default policy is policy number 254 for access interfaces, 255 for network interfaces
and no policy for video interfaces.
The no form of the command reverts to the default values.
Default cpu-protection 254 (for access interfaces)
cpu-protection 255 (for network interfaces)
none (for video-interfaces, shown as no cpu-protection in CLI)
The configuration of no cpu-protection returns the interface to the default policies as shown above.
cpu-protection
Syntax cpu-protection policy-id [mac-monitoring] [ip-src-monitoring]
no cpu-protection
Context config>subscriber-mgmt>msap-policy
Description Use this command to apply a specific CPU protection policy to the associated msap-policy. The
specified cpu-protection policy will automatically be applied to any MSAPs that are create using the
msap-policy.
If no CPU-protection policy is assigned to a SAP, then a default policy is used to limit the overall-rate
according to the default policy. The default policy is policy number 254 for access interfaces, 255 for
network interfaces and no policy for video interfaces.
The no form of the command reverts to the default values.
Default cpu-protection 254 (for access interfaces)
cpu-protection 255 (for network interfaces)
The configuration of no cpu-protection returns the msap-policy to the default policies as shown
above.
To Next Page
Loading...
