Security Commands
Page 248 7450 ESS System Mangement Guide
Sample Output
*A:nodeA# show service id 33 sap 1/1/3:33 dist-cpu-protection detail
===============================================================================
Service Access Points(SAP) 1/1/3:33
===============================================================================
Distributed CPU Protection Policy : test1
-------------------------------------------------------------------------------
Statistics/Policer-State Information
===============================================================================
-------------------------------------------------------------------------------
Static Policer
-------------------------------------------------------------------------------
Policer-Name : arp
Card/FP : 1/1 Policer-State : Conform
Protocols Mapped : arp
Exceed-Count : 0
Detec. Time Remain : 0 seconds Hold-Down Remain. : none
Operational (adapted) rate parameters:
Oper. Packets : 5 ppi Oper. Within : 8 seconds
Oper. Initial Delay: 6 packets
Oper. Depth : 0 packets
Policer-Name : dhcp
Card/FP : 1/1 Policer-State : Conform
Protocols Mapped : dhcp
Exceed-Count : 0
Detec. Time Remain : 0 seconds Hold-Down Remain. : none
Operational (adapted) rate parameters:
Oper. Kbps : 2343 kbps Oper. MBS : 240 kilobytes
Oper. Depth : 0 bytes
… (snip)
*A:nodaA# show service id 33 sap 1/1/3:34 dist-cpu-protection detail
Detec. Time Remain
The remaining time in the detection-time countdown during which a
policer in the exceed state is being monitored to see if it is once again
conformant.
Hold-Down Remain
The remaining time in the hold-down countdown during which a
policer is treating all packets as exceeding.
All Dyn-Plcr Alloc.
Indicates that all the dynamic enforcement policers have been allo-
cated and instantiated for a given local-monitor.
Dyn-Policer Alloc.
Indicates that a dynamic policer has been instantiated.
Table 17: Show Distributed CPU Protection Policer Output Fields (Continued)
Label Description
To Next Page
Loading...
