Tools Commands
Page 278 7450 ESS System Mangement Guide
Tools Commands
dist-cpu-protection
Syntax dist-cpu-protection
Context tools>perform>security
tools>dump>security
Description This command displays to release Distributed CPU Protection parameters and status at the per card
and forwarding plane level.
release-hold-down
Syntax release-hold-down interface interface-name [protocol protocol] [static-policer name]
release-hold-down sap sap-id [protocol protocol] [static-policer name]
Context tools>perform>security>dist-cput protection
Description This command is used to release a Distributed CPU Protection (DCP) policer from a hold-down
countdown (or indefinite hold-down if configured as such).
Parameters interface interface-name — Specifies Router interface name.
sap sap-id — Specify sap identifier.
protocol protocol — Specifies DCP protocol name (for example, arp, dhcp)
static-policer name — Specifies DCP static policer name as defined in the DCP policy.
violators
Syntax violators enforcement {sap|interface} card slot-number [fp fp-number]
violators local-monitor {sap|interface} card slot-number [fp fp-number]
Context tools>dump>security>dist-cput protection
Description This command shows the non-conformant enforcement policers and local monitors.
Parameters sap — -Indicates to display the violators associated with SAPs
interface — - Indicates to display the violators associated with router interfaces.
enforcement — Shows exceed and hold-down for Static and Dynamic Policers.
local-monitor — Shows state of dynamic policer allocation for Local Monitoring Policers.
To Next Page
Loading...
