Alcatel-Lucent 7450 - Page 339

NETCONF
7450 ESS System Mangement Guide Page 339
</item>
<item>
<cli-show>router mpls lsp</cli-show>
<response>
MINOR: CLI MPLS is not configured.
</response>
<rpc-error>
<error-type>application</error-type>
<error-tag>operation-failed</error-tag>
<error-severity>error</error-severity>
<error-info>
<err-element>cli-show</err-element>
</error-info>
<error-message>
command failed - 'show router mpls lsp'
</error-message>
</rpc-error>
</item>
</oper-data-format-cli-block>
</data>
</rpc-reply>
]]>]]>
<get-config>
<get-config> returns non-default configuration by default (i.e. the 'trim' mode as per
RFC 6243).
<edit-config>
The following values for the <test-option> parameter under <edit-config> are supported:
• test-then-set
• set
• test-only
<copy-config> and <delete-config>
The <copy-config> and <delete-config> base protocol operations are supported for specific
combinations of source and target datastores.
The <copy-config> operation is supported for the following combinations of sources and
targets:
• <source>=<url> and <target>=<startup> (as long as both are not remote urls)
• <source>=<startup> and <target>=<url> (as long as both are not remote urls)
• <source>=<running> and <target>=<url>
∅ Equivalent of "admin save <file-url>"
∅ An index file is also saved if "persist on" is configured in the bof