Alcatel-Lucent 7450 - Page 500

Accounting Policy Commands
Page 500 7450 ESS System Mangement Guide
43 kci-path-mgmt 5
44 complete-kpi 5
45 complete-kci 5
46 kpi-bearer-group 5
47 kpi-ref-path-group 5
48 kpi-kci-bearer-mgmt 5
49 kpi-kci-path-mgmt 5
50 kpi-kci-system 5
51 complete-kpi-kci 5
52 aa-performance 15
53 complete-ethernet-port 15
54 extended-service-ingress-egress 5
55 complete-network-ing-egr 15
56 aa-partition 15
57 complete-pm 5
0 unknown-record-name 0
59 kpi-bearer-traffic-gtp-endpoint 5
60 kpi-ip-reas 5
61 kpi-radius-group 5
62 kpi-ref-pt-failure-cause-code 5
63 kpi-dhcp-group 5
complete-pm 5
===========================================================
A:ALA-49#
To configure an accounting policy for access ports, select a service record (for example, service-
ingress-octets). To change the record name to another service record then the record command with
the new record name can be entered and it will replace the old record name.
When configuring an accounting policy for network ports, a network record should be selected.
When changing the record name to another network record, the record command with the new record
name can be entered and it will replace the old record name.
If the change required modifies the record from network to service or from service to network, then
the old record name must be removed using the no form of this command.
Only one record may be configured in a single accounting policy. For example, if an accounting-
policy is configured with a access-egress-octets record, in order to change it to service-ingress-
octets, use the no record command under the accounting-policy to remove the old record and then
enter the service-ingress-octets record.
Note that collecting excessive statistics can adversely affect the CPU utilization and take up large
amounts of storage space.
The no form of the command removes the record type from the policy.
Default No accounting record is defined
Parameters record-name — The accounting record name. The following table lists the accounting record names
available and the default collection interval.
Record Type Accounting Record Name Default Interval
1
service-ingress-octets
5
2
service-egress-octets
5