CLI Usage
Basic System Configuration Guide 101
Parameters port-id — Specifies up to 5 port IDs.
Values
atm — Keyword specifying ATM information.
interface-connection — Monitors ATM interface statistics.
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
Default Default mode delta
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
Default Default mode delta
aal-5 — Displays ATM Adaptation Layer 5 (AAL5) information.
ilmi — Monitors ATM ILMI statistics.
pvc — Identifies the port by the PVC identifier (vpi/vci).
pvp — Identifies the port by the permanent virtual path.
pvt — Identifies the port by the permanent virtual tunnel.
port-id slot/mda/port [.channel]
eth-sat-id esat-id/slot/port
esat keyword
id 1 to 20
pxc-id pxc-id.sub-port
pxc keyword
id 1 to 64
sub-port a, b
aps-id aps-group-id[.channel]
aps keyword
group-id 1 to 64
bundle ID bundle-type-slot/mda.bundle-num
bundle keyword
type ima, ppp
bundle-num 1 to 128
To Next Page
Loading...
