Basic CLI Command Reference
106 Basic System Configuration Guide
port
Syntax port port-id egress network queue-group queue-group-name instance instance-id
[interval seconds] [repeat repeat] [absolute | rate] [arbiter root | name]
Context monitor>qos>arbiter-stats
Description This command monitors arbiter statistics for a customer site.
Parameters port port-id — Specifies the port ID.
Values slot/mda/port
esat-id/slot/port
pxc-id.sub-port
egress network — Specifies statistics are for an egress network queue group.
Values network
queue-group queue-group-name — Specifies the name of the queue group up to 32 characters
in length.
instance instance-id — Specifies the identification of a specific instance of the queue-group.
Values 1to 65535
interval seconds — Configures the interval for each display in seconds.
Values 11 to 60
Default 11 seconds
repeat repeat — Configures how many times the command is repeated.
Values 1 to 999
Default 10
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed.
arbiter name — Specify the name of the policer control policy arbiter.
Values An existing arbiter-name in the form of a string up to 32 characters
long composed of printable, 7-bit ASCII characters. If the string
contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes.
root — Specifies the root arbiter.
sap
Syntax sap sap-id [arbiter name | root] [ingress | egress] [interval seconds] [repeat repeat]
[absolute | rate]
To Next Page
Loading...
