CLI Usage
Basic System Configuration Guide 105
arbiter name — Specifies the name of the policer control policy arbiter.
Values An existing arbiter-name in the form of a string up to 32 characters
long composed of printable, 7-bit ASCII characters. If the string
contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes.
root — Specifies the root arbiter.
customer
Syntax customer customer-id site customer-site-name [arbiter root | name] [ingress | egress]
[interval seconds] [repeat repeat] [absolute | rate]
Context monitor>qos>arbiter-stats
Description This command monitors arbiter statistics for a customer site.
Parameters customer-id — Specifies the ID number to be associated with the customer, expressed as an
integer.
Values 1 to 2147483647
site customer-site-name — Specifies the customer site which is an anchor point for ingress and
egress arbiter hierarchy.
arbiter name — Specify the name of the policer control policy arbiter. This parameter is
mandatory if the SAP resides on a LAG in adapt-qos link or port-fair mode.
Values An existing arbiter-name in the form of a string up to 32 characters
long composed of printable, 7-bit ASCII characters. If the string
contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes.
root — Specify the root arbiter.
ingress — Displays arbiter-name statistics applied on the site ingress.
egress — Displays arbiter-name statistics applied on the site egress.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed.
To Next Page
Loading...
