Basic CLI Command Reference
104 Basic System Configuration Guide
card
Syntax card slot-number fp fp-number queue-group queue-group-name instance instance-id
[ingress] [access | networks] [interval seconds] [repeat repeat] [absolute | percent-rate |
reference-rate] [arbiter root | name]
Context monitor>qos>arbiter-stats
Description This command monitors arbiter statistics in an ingress FP queue group.
Parameters card slot-number — Specifies the slot number associated with the queue group, expressed as an
integer.
Values 1 to 20
fp fp-number — Specifies the FP number associated with the queue group, expressed as an
integer.
Values 1 to 2
queue-group queue-group-name — Specifies the name of the queue group up to 32 characters in
length.
instance instance-id — Specifies the identification of a specific instance of the queue-group.
Values 1to 65535
ingress — Displays arbiter-name statistics applied on the ingress FP.
access — Displays arbiter-name statistics applied on the FP access.
network — Displays arbiter-name statistics applied on the FP network.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 to 60
repeat repeat
— Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
percent-rate — When the percent-rate keyword is specified, the rate-per-second for each statistic
is displayed based on the reference rate of 10G.
reference-rate — When a reference-rate value is specified, the rate-per-second for each statistic is
displayed as a percentage based on the reference rate specified.
Values 100M, 1G, 10G, 40G, 100G, 400G
To Next Page
Loading...
