Basic CLI Command Reference
108 Basic System Configuration Guide
ingress — Displays scheduler-name statistics applied on the ingress SAP.
egress — Displays scheduler-name statistics applied on the egress SAP.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
customer
Syntax customer customer-id site customer-site-name [scheduler scheduler-name] [ingress |
egress] [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>qos>scheduler-stats
Description Use this command to monitor scheduler statistics per customer multi-service-site. The first screen
displays the current statistics related to the specified customer ID and customer site name. The
subsequent statistical information listed for each interval is displayed as a delta to the previous display.
When the keyword rate is specified, the "rate per second" for each statistic is displayed instead of the
delta.
Monitor commands are similar to show commands but only statistical information displays. These
commands display selected statistics per the configured number of times at the interval specified.
Parameters customer-id — Specifies the ID number to be associated with the customer, expressed as an
integer.
Values 1 to 2147483647
site customer-site-name — Specify the customer site which is an anchor point for ingress and
egress virtual scheduler hierarchy.
scheduler scheduler-name — Specify an existing scheduler-name. Scheduler names are
configured in the config>qos>scheduler-policy>tier level context. This parameter is
mandatory if the customer resides on a LAG in adapt-qoslink or port-fair mode.
Values An existing scheduler-name is in the form of a string up to 32
characters long composed of printable, 7-bit ASCII characters. If
the string contains special characters (#, $, spaces, etc.), the entire
string must be enclosed within double quotes.
ingress — Displays the customer’s multi-service-site ingress scheduler policy.
To Next Page
Loading...
