CLI Usage
Basic System Configuration Guide 109
egress — Displays the customer’s multi-service-site egress scheduler policy.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
sap
Syntax sap sap-id [scheduler scheduler-name] [ingress | egress] [interval seconds] [repeat
repeat] [absolute | rate]
Context monitor>qos>scheduler-stats
Description Use this command to monitor scheduler statistics for a SAP at the configured interval until the
configured count is reached.
The first screen displays the current statistics related to the specified SAP. The subsequent statistical
information listed for each interval is displayed as a delta to the previous display.
When the keyword rate is specified, the "rate per second" for each statistic is displayed instead of the
delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition.
scheduler scheduler-name — Specify an existing scheduler-name. Scheduler names are
configured in the config>qos>scheduler-policy>tier level context. This parameter is
mandatory if the SAP resides on a LAG in adapt-qoslink or port-fair mode.
Values An existing scheduler-name in the form of a string up to 32
characters long composed of printable, 7-bit ASCII characters. If
the string contains special characters (#, $, spaces, etc.), the entire
string must be enclosed within double quotes.
ingress — Displays scheduler-name statistics applied on the ingress SAP.
egress — Displays scheduler-name statistics applied on the egress SAP.
To Next Page
Loading...
