Basic CLI Command Reference
110 Basic System Configuration Guide
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
subscriber
Syntax subscriber sub-ident-string [scheduler scheduler-name] [ingress | egress] [interval
seconds] [repeat repeat] [absolute | rate]
Context monitor>qos>scheduler-stats
Description This command monitors scheduler statistics for a subscriber and is supported on the 7740 ESS and
7750 SR.
Parameters sub-ident-string — Specifies an existing subscriber a identification policy name.
scheduler scheduler-name — Specify an existing QoS scheduler policy name. Scheduler names
are configured in the config>qos>scheduler-policy>tier level context.
Values An existing scheduler-name in the form of a string up to 32
characters long composed of printable, 7-bit ASCII characters. If
the string contains special characters (#, $, spaces, etc.), the entire
string must be enclosed within double quotes.
ingress — Displays scheduler-name statistics applied on the ingress SAP.
egress — Displays scheduler-name statistics applied on the egress SAP.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
To Next Page
Loading...
