CLI Usage
Basic System Configuration Guide 111
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
port
Syntax port port-id queue-group queue-group-name [ingress | egress] [interval seconds]
[repeat repeat] [absolute | rate] [access | network] [instance instance-id]
Context monitor>qos>scheduler-stats
Description This command monitors scheduler statistics in a port queue group.
Parameters port port-id — Specifies the port ID.
Values slot/mda/port
esat-id/slot/port
pxc-id.sub-port
queue-group queue-group-name — Specifies the name of the queue group up to 32 characters
in length.
instance instance-id — Specifies the identification of a specific instance of the queue-group.
Values 1to 65535
ingress — Specifies statistics are for an ingress queue group.
egress — Specifies statistics are for an egress queue group.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed.
access — Displays scheduler statistics applied on an access port.
network — Displays scheduler statistics applied on a network port.
port
Syntax port port-id vport name [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>qos>scheduler-stats
To Next Page
Loading...
