Basic CLI Command Reference
112 Basic System Configuration Guide
Description This command monitors scheduler statistics in a VPORT.
Parameters port port-id — Specifies the port ID.
Values slot/mda/port
esat-id/slot/port
pxc-id.sub-port
vport name — Displays statistics for the named VPORT.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed.
sap
Syntax sap sap-id encap-group group-name [member encap-id] [scheduler scheduler-name]
[interval seconds] [repeat repeat] [absolute | rate]
Context monitor>qos>scheduler-stats
Description This command monitors scheduler statistics for a SAP encap-group.
Parameters sap sap-id — Specify the physical port identifier portion of the SAP definition.
encap-group group-name — Displays statistics for the encap group.
member encap-id — The value of the encap-id to be displayed.
Values 0 to 16777215
scheduler scheduler-name — Specify an existing scheduler-name. Scheduler names are
configured in the config>qos>scheduler-policy>tier level context. This parameter is
mandatory if the SAP resides on a LAG in adapt-qoslink or port-fair mode
Values An existing scheduler-name is in the form of a string up to 32
characters long composed of printable, 7-bit ASCII characters.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 to 60
To Next Page
Loading...
