Basic CLI Command Reference
138 Basic System Configuration Guide
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
virtual-neighbor
Syntax virtual-neighbor nbr-rtr-id area area-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>router>ospf
monitor>router>ospf3
Description This command displays statistical OSPF virtual neighbor information at the configured interval until
the configured count is reached.
The first screen displays the current statistics related to the specified OSPF virtual neighbor router. The
subsequent statistical information listed for each interval is displayed as a delta to the previous display.
When the keyword rate is specified, the rate-per-second for each statistic is displayed instead of the
delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters nbr-rtr-id — The IP address to uniquely identify a neighboring router in the autonomous system.
area area-id — The OSPF area ID, expressed in dotted decimal notation or as a 32-bit decimal
integer.
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
To Next Page
Loading...
