CLI Usage
Basic System Configuration Guide 139
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
group
Syntax group grp-ip-address [source ip-address] [interval interval] [repeat repeat] [absolute | rate]
Context monitor>router>pim
Description This command monitors statistics for a PIM source group.
Parameters grp-ip-address — The IP address of an multicast group that identifies a set of recipients that are
interested in a particular data stream.
source ip-address — The source IP address to use in the ping requests in dotted decimal notation.
Default The IP address of the egress IP interface.
Values 0.0.0.0 to 255.255.255.255
interval interval — Configures the interval for each display in seconds.
Default 10 seconds
Values 10 | 20 | 30 | 40 | 50 | 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
neighbor
Syntax neighbor neighbor [neighbor...(up to 5 max)] [interval seconds] [repeat repeat] [absolute |
rate]
Context monitor>router>rip
Description This command displays statistical RIP neighbor information at the configured interval until the
configured count is reached.
The first screen displays the current statistics related to the specified RIP neighbor(s). The subsequent
statistical information listed for each interval is displayed as a delta to the previous display. When the
keyword rate is specified, the rate-per-second for each statistic is displayed instead of the delta.
To Next Page
Loading...
