CLI Usage
Basic System Configuration Guide 141
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
service
Syntax service
Context monitor
Description This command enables the context to configure criteria to monitor specific service SAP criteria.
id
Syntax id service-id
Context monitor>service
Description This command displays statistics for a specific service, specified by the service-id, at the configured
interval until the configured count is reached.
The first screen displays the current statistics related to the service-id. The subsequent statistical
information listed for each interval is displayed as a delta to the previous display. When the keyword
rate is specified, the rate-per-second for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters service-id — The unique service identification number which identifies the service in the service
domain.
sap
Syntax sap sap-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>service>id
Description This command monitors statistics for a SAP associated with this service.
To Next Page
Loading...
