Alcatel-Lucent 7450 - Page 172

The File System
172 Basic System Configuration Guide
Example: A:ALA-1>file cf3:\ # copy test*.cfg
siliconvalleycf1:\testfile.cfg
1 file(s) copied.
A:ALA-1>file cf3:\ # cd siliconvalley
A:ALA-1>file cf3:\siliconvalley\ # dir
Volume in drive cf1 on slot A has no label.
Directory of cf3:\siliconvalley\
05/10/2006 11:32p <DIR> .05/10/2006
11:14p <DIR> ..
05/10/2006 11:32p 7597 testfile.cfg
1 File(s) 7597 bytes.
2 Dir(s) 1082368 bytes free.
A:ALA-1>file cf3:\siliconvalley\ #
As in a DOS file system, the wildcard characters can only be used in some of the file
commands.
Another example of wildcard usage:
A:21# show router mpls lsp l-63-8*
===============================================================================
MPLS LSPs (Originating)
===============================================================================
LSP Name To Fastfail
Adm Opr
Config
-------------------------------------------------------------------------------
l-63-8-cc 213.224.245.8 No
Up Dwn
l-63-8-cw 213.224.245.8 No
Up Dwn
-------------------------------------------------------------------------------
LSPs : 2
===============================================================================
A:21#
All the commands can operate on the local file system. Table 25 indicates which commands
also support remote file operations.
Table 25: File Command Local and Remote File System Support
Command local-url ftp-url tftp-url
attrib X
cd X X
copy X X X
delete X X
dir X X