System Command Reference
394 Basic System Configuration Guide
local-url — [cflash-id/] [file-path]
200 chars max, including cflash-id
directory length 99 characters max each
remote url — [{ftp:// | tftp://}login:password@remote-location/
][file-path]
255 characters max
directory length 99 characters max each
remote-location — [hostname | ipv4-address | ipv6-address]
ipv4-address — a.b.c.d
ipv6-address — x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x — [0..FFFF]H
d — [0..255]D
interface — 32 characters max, for link local addresses
cflash-id — cf1: | cf1-A: | cf1-B: | cf2: | cf2-A: | cf2-B: | cf3: | cf3-
A: | cf3-B:
System Time Commands
dst-zone
Syntax [no] dst-zone [std-zone-name | non-std-zone-name]
Context config>system>time
Description This command configures the start and end dates and offset for summer time or daylight savings time
to override system defaults or for user defined time zones.
When configured, the time is adjusted by adding the configured offset when summer time starts and
subtracting the configured offset when summer time ends.
If the time zone configured is listed in Table 29, then the starting and ending parameters and offset do
not need to be configured with this command unless it is necessary to override the system defaults. The
command returns an error if the start and ending dates and times are not available either in Table 29
on or entered as optional parameters in this command.
Up to five summer time zones may be configured, for example, for five successive years or for five
different time zones. Configuring a sixth entry will return an error message. If no summer (daylight
savings) time is supplied, it is assumed no summer time adjustment is required.
The no form of the command removes a configured summer (daylight savings) time entry.
Default none — No summer time is configured.
To Next Page
Loading...
