System Management
Basic System Configuration Guide 437
Description This command specifies a peer name.
Parameters name — The string may be up to 32 characters long. Any printable, seven-bit ASCII characters
can be used within the string. If the string contains special characters (#, $, spaces, etc.), the
entire string must be enclosed within double quotes.
pim-snooping
Syntax pim-snooping [saps]
no pim-snooping
Context config>redundancy>multi-chassis>peer>sync
Description This command specifies whether PIM snooping for IPv4 information should be synchronized with the
multi-chassis peer. Entering only pim-snooping (without any parameter) results in the
synchronization being applicable only to SAPs.
Default no pim-snooping
Parameters saps — Specifies that SAPs are to be synchronized with the multi-chassis peer relating to sync-
tags configured on ports. This is the default when no parameters are included.
port
Syntax port [port-id | lag-id] [sync-tag sync-tag]
no port [port-id | lag-id]
Context config>redundancy>multi-chassis>peer>sync
Description This command specifies the port to be synchronized with the multi-chassis peer and a synchronization
tag to be used while synchronizing this port with the multi-chassis peer.
Parameters port-id — Specifies the port to be synchronized with the multi-chassis peer.
lag-id — Specifies the LAG ID to be synchronized with the multi-chassis peer.
sync-tag sync-tag — Specifies a synchronization tag to be used while synchronizing this port
with the multi-chassis peer.
python
Syntax python
Context config>redundancy>multi-chassis>peer>sync
Description This command enables syncing of python-policy cached entries to the peer.
Use the mcs-peer command in the python-policy to enable syncing for a specific python-policy.
To Next Page
Loading...
