System Command Reference
438 Basic System Configuration Guide
Default no python
range
Syntax range encap-range sync-tag sync-tag
no range encap-range
Context config>redundancy>multi-chassis>peer>sync>port
Description This command configures a range of encapsulation values.
Parameters encap-range — Specifies a range of encapsulation values on a port to be synchronized with a
multi-chassis peer.
Values Dot1Qstart-vlan-end-vlan
QinQQ1.start-vlan-Q1.end-vlan
sync-tag sync-tag — Specifies a synchronization tag up to 32 characters in length to be used
while synchronizing this encapsulation value range with the multi-chassis peer.
source-address
Syntax source-address ip-address
no source-address
Context config>redundancy>multi-chassis>peer
Description This command specifies the source address used to communicate with the multi-chassis peer.
Parameters ip-address — Specifies the source address used to communicate with the multi-chassis peer.
srrp
Syntax [no] srrp
Context config>redundancy>multi-chassis>peer>sync
Description This command specifies whether subscriber routed redundancy protocol (SRRP) information should
be synchronized with the multi-chassis peer. This command applies to the 7450 ESS and 7750 SR.
Default no srrp
sync
Syntax [no] sync
To Next Page
Loading...
