Show, Clear, Debug, and Tools Command Reference
498 Basic System Configuration Guide
Description This command enables the context to show redundancy information.
mgmt-ethernet
Syntax mgmt-ethernet
Context show>redundancy
Description This command shows the management Ethernet port redundancy status. The show router
“management” interface command also shows the CPM Ethernet port used by the management
interface. If the primary CPM’s port is active, then it shows “A/1” under the Port field,. If the
secondary CPM’s port is active, then it shows “B/1 -> A/1”in the Port field.
This feature is not supported on 7750 SR-a, 7750 SR-c or VSR platforms.
Output Show Redundancy Mgmt-Ethernet Output
The following table describes the Redundancy Mgmt-Ethernet fields:
Sample Output
A:SR12# show redundancy mgmt-ethernet
===============================================================================
Management Ethernet Redundancy
===============================================================================
Admin Status : Enabled
Oper Status : Management port operating on active CPM
Revert Time : 5 seconds
===============================================================================
Show Router “Management” Interface Detail Output
The following is a sample output that shows “A/1” when the primary CPM’s Ethernet port is active
and “B/1 ->A/1” if the secondary CPM’s port is active.
*B:Dut-A# show router "management" interface
===========================================================================
Interface Table (Router: management)
===========================================================================
Table 55: Redundancy Mgmt-ethernet Field Descriptions
Label Description
Admin Status Enabled — Administrative status is enabled.
Disabled — Administratively disabled.
Oper Status Displays the CPM on which the management Ethernet port is operating.
Revert Time Displays the revert time.
To Next Page
Loading...
