System Management
Basic System Configuration Guide 503
Packets Tx Peer Config : 30
Packets Tx Failed : 0
Packets Dropped No Peer : 0
===============================================================================
*A:Dut-B#
*A:Dut-B# show redundancy multi-chassis mc-endpoint endpoint 1 statistics
===============================================================================
Multi-Chassis Endpoint Statistics
===============================================================================
===============================================================================
MC-Endpoint Id 1
===============================================================================
Packets Rx Config : 3
Packets Rx State : 7
Packets Tx Config : 2
Packets Tx State : 4
Packets Tx Failed : 0
===============================================================================
Number of Entries 1
===============================================================================
mc-lag
Syntax mc-lag [lag lag-id]
Context show>redundancy>multi-chassis
Description This command displays multi-chassis LAG information.
Parameters lag lag-id — Shows information for the specified LAG identifier.
Values 1 to 800
peer
Syntax peer ip-address [lag lag-id]
Context show>redundancy>multi-chassis>mc-lag
Description This command enables the context to display mc-lag peer-related redundancy information.
Parameters ip-address — Shows peer information about the specified IP address.
lag lag-id — Shows information for the specified LAG identifier.
Values 1 to 800
Output The following table describes show redundancy multi-chassis mc-lag peer output fields:
To Next Page
Loading...
