System Management
Basic System Configuration Guide 505
statistics
Syntax statistics mc-lag [peer ip-address [lag lag-id]]
Context show>redundancy>multi-chassis>mc-lag
Description This command displays multi-chassis statistics.
Parameters mc-lag — Displays multi-chassis LAG statistics.
peer ip-address — Shows the specified address of the multi-chassis peer.
lag lag-id — Shows information for the specified LAG identifier.
Values 1 to 800
Output The following table describes show redundancy multi-chassis mc-lag peer output fields:
Table 58: Redundancy Multi-chassis MC-Lag Peer Statistics Field Descriptions
Label Description
Packets Rx Indicates the number of MC-Lag packets received from the peer.
Packets Rx
Keepalive
Indicates the number of MC-Lag keepalive packets received from the
peer.
Packets Rx Config Indicates the number of received MC-Lag configured packets from the
peer.
Packets Rx Peer
Config
Indicates the number of received MC-Lag packets configured by the peer.
Packets Rx State Indicates the number of MC-Lag “lag” state packets received from the
peer.
Packets Dropped State
Disabled
Indicates the number of packets that were dropped because the peer was
administratively disabled.
Packets Dropped
Packets Too Short
Indicates the number of packets that were dropped because the packet
was too short.
Packets Dropped Tlv
Invalid Size
Indicates the number of packets that were dropped because the packet
size was invalid.
Packets Dropped Tlv
Invalid LagId
Indicates the number of packets that were dropped because the packet
referred to an invalid or non multi-chassis lag.
Packets Dropped Out
of Seq
Indicates the number of packets that were dropped because the packet
size was out of sequence.
Packets Dropped
Unknown Tlv
Indicates the number of packets that were dropped because the packet
contained an unknown TLV.
To Next Page
Loading...
