CLI Usage
Basic System Configuration Guide 71
[hop hop] [router router-instance] [wait-time wait-time]
Context <global>
Description This command traces a multicast path from a source to a receiver and displays multicast packet rate
and loss information. This command applies to the 7750 SR and 7950 XRS.
Parameters ip-address — Specify the ip-address of the multicast capable target router.
dns-name — Specify the DNS name (if DNS name resolution is configured).
Values 63 characters maximum
group group-ip-address — Specify the multicast address of the group to be displayed.
destination dst-ip-address — Specify the unicast destination address.
hop count — Specify the maximum number of hops that will be traced from the receiver back
toward the source.
Values 1 to 255
Default 32 hops (infinity for the DVMRP routing protocol).
router router-instance — Specify the router name or service ID.
Values
Default Base
wait-time wait-time — Specify the number of seconds to wait for the response.
Values 1 to 60
mtrace
Syntax mtrace source [ip-address | dns-name] [group grp-ip-address] [destination dst-ip-address]
[hop hop] [router router-instance] [wait-time wait-time]
Context <global>
Description This command traces a multicast path from a source to a receiver. This command applies to the
7750 SR and 7950 XRS.
Parameters ip-address — Specify the ip-address of the multicast capable target router.
dns-name — Specify the DNS name (if DNS name resolution is configured).
Values 63 characters maximum
router-name: Base, management
service-id: 1 to 2147483647
To Next Page
Loading...
