CLI Usage
Basic System Configuration Guide 93
Parameters lag-id — The number of the LAG.
Default none — The LAG ID value must be specified.
Values 1 to 800
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
Output
Sample Output
A:ALA-12# monitor lag 12
===============================================================================
Monitor statistics for LAG ID 12
===============================================================================
Port-id Input Input Output Output Input Output
Bytes Packets Bytes Packets Errors Errors
-------------------------------------------------------------------------------
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
1/1/1 2168900 26450 64100
1/1/2 10677318 125610 2273750 26439 0 0
1/1/3 2168490 264450000
-------------------------------------------------------------------------------
Totals 15014708 178505 2273814 26440 0 0
-------------------------------------------------------------------------------
At time t = 5 sec (Mode: Delta)
-------------------------------------------------------------------------------
1/1/1 0 0 0 0 00
1/1/2 258 3 86100
1/1/3 82 10000
-------------------------------------------------------------------------------
Totals 340 4 86100
===============================================================================
A:ALA-12#
lsp-egress-stats
Syntax lsp-egress-stats
lsp-egress-stats lsp-name
To Next Page
Loading...
